Use a
floor jack to assist in the positioning of the Footplate.
8.Install Flip Flop
Frame to Seat Back Support Brackets & Vertical Supports.
See Figure 4 for a view of the final assembly.
Use:
Hardware Bag # 3 with 17mm socket & wrench.
9.Install Hand Rails
to the sides of Flip Flop Frame. See Figure 4.
Use:
Hardware Bag # 2 with 17mm wrench & #3 Phillips screw
driver.
10.Install Hand Rails to the sides of
Footplate. See Figure 4.
Use:
Hardware Bag # 1 with 17mm sockets.
11.Install Rear Seat Back Bracket between
Hand Rails. See Figure 4.
Use:
Hardware Bag # 2 with 17mm socket & #3 Phillips screw
driver.
12.Install Seat Back Cushion.
Use:
Hardware Bag # 4 with 10mm socket.
13.Position Seat Bottom
Cushion using (2) existing pilot holes in Seat Bottom
Cushion
and (2) wood screws. Note: Make sure the pull strap is not
trapped
under the cushion. Using drill, drill (6) additional pilot holes into Seat
Bottom
Cushion and then complete installation.
Use:
1/8" or 3mm drill bit.
Hardware
Bag #
6 with #2 Phillips screw driver/drill bit.
14.Install top canopy using hardware
from Step 1.
|
